Getting started

Scopes

The Intensity Mode is based on several scopes related to the measurement surface. The top level is the Total Scope. To enter a lower scope, double-tap the surface or segment of interest. To move up a scope, press the Back softbutton.

The Total Scope shows the total result, and presents a graphical view of all surfaces included in the project.

The Surface Scope displays the result for one surface, and presents all segments inside the surface.

The Segment Scope shows the results for a single segment. If no measurement is stored, instantaneous measurement values are presented.

Keys

This key toggles through the available views in each scope:

Scope View

Simple View

Advanced View

For the Segment Scope, the Scope View is not available. If no measured values exist, Idle View will be presented.

Toggles between a graphical representation and a numerical table.

Toggles through different functions depending on the current scope and view.

Toggles the Info View when in Idle View, and the Warning View otherwise.

Context sensitive menus

Several functions are easily avaialable in the context menu. The context menu is described in detail for each view. To open the context menu, tap and hold on the graphical content on the screen, or press the ü button.

Softkeys

The softkeys change depending on the context of the current view.

Returns to scope view or steps one scope up.

Behaves like the hard key.

Behaves like the hard button.

Enables additional information to be added to the project, and is described in details here:

Notes

Status bar

The status bar contains important information about the instrument and the measurement.

Status Bar

NorRemote

Setup NorRemote:

Enable NorRemote

More information

Tap here for an introduction to the help system.

Sound Intensity help index